Test Unity XT CSI Driver
Test deploying a simple Pod and Pvc with Unity XT storage
In the repository, a simple test manifest exists that creates three different PersistentVolumeClaims using default NFS and iSCSI and FC storage classes and automatically mounts them to the pod.
- To run this test, run the kubectl command from the root directory of the repository:
kubectl create -f ./test/sample.yaml
You can find all the created resources in
Check if the pod is created and Ready and Running by running:
kubectl get all -n test-unity
If it is in CrashLoopback state then the driver installation was not successful. Check the logs of the node and the controller.
Go into the created container and verify that everything is mounted correctly.
After verifying, you can uninstall the testing PVCs and StatefulSet.
kubectl delete -f ./test/sample.yaml
Support for SLES 15 SP2
The CSI Driver for Dell Unity XT requires the following set of packages installed on all worker nodes that run on SLES 15 SP2.
- open-iscsi open-iscsi is required in order to make use of iSCSI protocol for provisioning
- nfs-utils nfs-utils is required in order to make use of NFS protocol for provisioning
- multipath-tools multipath-tools is required in order to make use of FC and iSCSI protocols for provisioning
After installing open-iscsi, ensure “iscsi” and “iscsid” services have been started and /etc/isci/initiatorname.iscsi is created and has the host initiator id. The pre-requisites are mandatory for provisioning with the iSCSI protocol to work.